Install CH34X Driver on Windows and Mac
The CH34X family comprises widely used USB‑to‑serial chips manufactured by WCH (WinChipHead), commonly integrated into generic UNO R3, ESP8266, and ESP32 development boards.
Lonely Binary |
Learn
Install CH34X Driver on Windows and Mac
-
-
ESP-01S How to Use TX and RX as GPIO
If your circuit uses TX (GPIO1) as an output and RX (GPIO3) as an input then all you need to do is not call Serial.begin( ) as this is the...
Lonely Binary |
-
ESP-01S I2C Bus
The I2C bus offers an elegant solution, enabling the connection of numerous sensors and displays with ease.
Lonely Binary |
-
ESP-01S Boot Mode
The ESP-01S has two primary boot modes: Flash mode and Normal Operation mode. Flash mode is for uploading code, while Normal Operation mode runs the code.
Lonely Binary |
-
ESP-01S Programming using Arduino IDE
To effectively utilize the ESP-01S module with Arduino IDE, it's imperative to install the ESP8266 plugin.
Lonely Binary |
-
-
Hands-on ESP-01S Series
Introduction Pinout Schematic Buildin Led Programming Using Arduino IDE [todo] Programming Using Platform IO [todo] Programming Using AT-Command Boot Mode Using TX and RX as GPIO Using GPIO0 and...
Lonely Binary |
-
ESP-01S Introduction
The ESP8285 made its debut in 2016 and is fully compatible with the ESP8266.
Lonely Binary |
-
ESP-01S Buildin LED
When GPIO2 is set to a logic LOW state, it closes the circuit, causing the LED to illuminate.
Lonely Binary |
-
Sound Detection Microphone Sensor Tutorial in Arduino UNO R3
This tutorial shows how to use the microphone sound sensor with the Arduino board.
Cisco Kid |
-
How to use the HC-SR505 PIR sensor with the Arduino UNO R3
This tutorial will shows you a few simple steps about how to use Motion Sensor Module by using Arduino Uno.
Cisco Kid |
-
Light Sensor (Photoresistor) With Arduino UNO R3
Discovering the process of reading a photoresistor becomes an exciting endeavor when utilizing Arduino's Analog Input.
Cisco Kid |
-
How to use ESP-01S with ESP8285 MCU
The ESP-01s 2023 version, featuring the latest ESP8285 MCU. This new iteration maintains full compatibility with the previous ESP-01 model, which used the ESP8266EX MCU. The ESP8266EX has been discontinued...
Lonely Binary |
