Description
A base for the ESP32-C3 OLED with push-in terminals: bare wire goes in without a screwdriver. The board plugs into the two black sockets in the middle, each of its sixteen holes comes out to its own terminal, and a LiPo connector, charger and power switch are built in.
Highlights
- Push-in terminals. Two blocks of eight 3.5 mm ways, one down each side.
- Battery power. JST PH 2.0 connector, TP4054 charger and a slide switch. Plug in USB with the switch ON and a cell connected to charge it.
- Battery monitor. An open solder jumper connects a divider across the cell to GPIO 2, so a sketch can read its own battery level.
- Two 4.8 mm mounting holes, 16 mm apart.
In the box
- 1 × ESP32-C3 OLED pluggable terminal base, terminal blocks fitted
The ESP32-C3 OLED board, the battery and cables are not included.
Specifications
- Terminals: 2 × 8 push-in, 3.5 mm pitch
- Battery: JST PH 2.0, single 3.7 V lithium cell with a protection circuit
- Size: 53.1 × 32.5 mm, 14.9 mm tall from the underside
Seat the board with its antenna at the power-switch end and its USB-C socket at the battery-connector end.
Questions
ESP32-C3 OLED Screwless Terminal Base, Push-in with LiPo Charger
Free shipping over €35
- Ships worldwide
- 30-day returns
- 12-month warranty
What's in the box
parts, each with its own handbook
Tap any part for its wiring, example code for Arduino and MicroPython, and a 3D model you can turn over.
Datasheets, CAD and the handbook
Everything you need to design with it, before you buy it. Free from Lonely Binary Learn.
Stuck? Ask the people who made it
Email office@lonelybinary.com with your setup and what it is doing. Our product team answers within 24 hours.
