Description

Three ATmega328P Nano V3.0 boards with USB-C, plus a PinPulse shield that puts a status LED on every I/O pin. For learning Arduino and debugging circuits at a glance.

Highlights

• See every pin. The PinPulse shield shows HIGH or LOW on TX/RX, D2 to D13 and A0 to A7.
• Buffered LEDs. SN74HC04D inverters drive the LEDs, keeping the load off your I2C, SPI and UART signals.
• Male and female on every pin. Dual 2.54 mm headers take any jumper wire type.
• USB-C. A reversible connector on every Nano.
• Arduino IDE compatible. Existing Nano sketches, libraries and shields work as they are.

In the box

• 3 × Nano V3.0 board, USB-C
• 1 × PinPulse shield
• 1 × USB-C cable
• 1 × printed quick-start card (CH340 driver and Arduino IDE setup)

Specifications

• Microcontroller: ATmega328P at 16 MHz
• Flash: 32 KB
• SRAM: 2 KB
• EEPROM: 1 KB
• Digital I/O: 14, 6 with PWM
• Analog inputs: 8
• USB serial: CH340

Works with

Arduino IDE. Sensor and display modules shown in photos are not included.